Antero Resources Mitigation Strategies and BMP - Wolf Springs Mesa County

Wolf Springs, Mesa County

Antero Resources’ Mitigation Strategies and Best Management Practices:

Wolf Springs, Mesa County

continue reading...

Air Quality and Odor Control


  • All production tank venting emissions are routed to a VOC combustor
    • Purpose is to reduce odors by controlling VOC emissions from condensate flashing and working and breathing losses
    • VOC combustors operate with auto-igniters
      • Purpose is to keep VOC combustors lit
      • Flowback gas and well flow testing gas routed to temporary flare
      • Well Pad Location Telemetry/Remote Monitoring
        • Reduces well pad location truck/pumper visits
        • Low profile antenna equipment
        • Frac/Flowback Storage Tank Hatches
          • Tank hatches are closed and latched until the tanks are being prepared to receive flowback water
            • Hatches closed but unlatched when receiving flowback fluids
  • Operate with odor absorbing blanket or other similar odor control device when full
  • Diesel Powered Drilling Rig Generators
    • Drill rig engines are regulated as non-road engines under the Standards of Performance for Stationary Compression Ignition Internal Combustion Engines (40CFR 60, 85)
    • Diesel engines powering the drilling rigs are certified to at least the Tier 2/3 standards
      • Ensure that engine fuel meets regulated sulfur content requirements.
      • Separators and Wellheads – Fugitive VOC emissions from valves and flanges
        • Operate with low-bleed pneumatic devices


Fugitive Dust


  • Well pad location and access roads graveled to reduce dust impacts
    • Soiltac® and/or liquid dust suppressants are used to mitigate fugitive dust emissions on access roads and well pad location
    • Buried water lines to minimize fugitive dust emissions from truck traffic
    • Limiting vehicle speeds during well pad location site access
      • Road sweeping to reduce fugitive dust and mud tracking onto roadways where practicable



Groundwater and Surface Water Resources


  • Closed loop (pitless) drilling systems; no reserve, drill cuttings or frac/flowback pits will be constructed
  • Water used for well completions will be recycled as practicable
  • Frac/Flowback tank area lined and/or tanks equipped with portable spill berm containment structures
  • Production tank containment area bermed and lined with plastic
  • Well pad location perimeter berms to contain unintended fluid releases
  • Voluntary Water Well Testing Program
    • Pre - all water wells/springs within ½ mile radius of the surface-hole location for each well on a well pad location
    • Post – within one year a follow-up test on the pretest wells/springs or when all wells drilled and completed on a well pad location
    • Where practical water quality testing as requested by landowner for water wells, springs, potable water and agriculture water
      • Comply with provisions of water well testing in surface use agreements
      • Wetland/drainage survey and mapping conducted prior to site disturbance
        • Containment for well pad location within 500 feet of surface water is 110 percent secondary containment for any volume of fluids contained at a well pad location during drilling and completion operations


Planning Infrastructure and Development Activities which Minimize Impact


  • Antero setbacks of 500 feet from dwelling units – COGCC setbacks are 150-200 feet
  • Well pad location construction not to exceed 3.5 acres
  • Bury all gas and water pipelines adjacent to roads whenever possible
  • Water used for well completions will be recycled as practicable
    • Above-ground facilities located to minimize visual effects (e.g. production tanks will be low profile tanks and painted to mitigate visual impacts)


Spill Prevention, Control and Countermeasure (SPCC Program)


  • Annual SPCC Training
  • SPCC inspections conducted quarterly
  • Well pad location perimeter berms will be constructed
    • Purpose is to provide tertiary spill containment for production tanks and separators
    • Provides secondary spill containment for all material activities on site not just oil storage.
    • Provides a barrier between well pad location activities and surrounding areas
    • Frac/Flowback tank area will be located in an area with down gradient well pad location perimeter berm
      • Frac/Flowback tank area lined to mitigate seepage losses from the unintended spillage of well completion fluids, or frac/flowback tanks will be placed in portable spill berms
      • Standard Operating Procedures (SOPs) training performed for handling and transfer of frac/flowback and produced fluids
      • High level overflow alarms installed on production tanks
      • Covered drip buckets for condensate and produced water tanks and loadout lines
        • Purpose is to minimize spillage and drips that occur during normal loading activities
        • Designed to catch residual liquids that remain in lines after the tank valves and truck valves have been closed
        • Covers minimize VOC emissions and exposure to storm water



Stormwater Management


  • Facilities operated with a Water Quality Control Division (WQCD) stormwater construction permit
    • Stormwater BMPs in accordance with the Stormwater Management Plan will be implemented in a manner that minimizes erosion, transport of sediment offsite, and site degradation
    • Inspections will be conducted every two weeks/monthly and after a precipitation or runoff event in accordance with WQCD General Permit to confirm that applicable BMPs are in place, maintained and functioning properly
    • Straw wattles and erosion blankets or other suitable erosion control devices are used to prevent sediment from leaving the site
    • Site Preparation conducted to establish stable slopes, water courses and drainage features to minimize erosion and sedimentation


Invasive Non-Native Vegetation Control


  • Weed management plan will be developed and implemented to monitor and control noxious and invasive weeds
  • Noxious weed control includes three treatments per year
    • Existing weed infestations will be mapped prior to the development of each pad, access road and pipeline when practicable
    • Reclamation/revegetation will be used as a weed management tool
Complete the form below to download this document now.
Fill out the form to get access to the complete article.